Filter
Top Products
SpectraLink Corporation NetLink e340/h340/i640 Wireless Telephones and Accessories User Guide
Part Number: 72-1004-01-J.doc
Page 35
General Care of the Handsets and Chargers
This section applies to all NetLink Wireless Telephones, the
Docking Station and all SpectraLink chargers.
Do not drop
Avoid dropping the handset or knocking it against hard surfaces.
Carrying the handset in a holster or carrying case will help to
protect it.
Do not disassemble
There are no serviceable parts in the handset, Docking Station or
chargers. You should not open the handset case nor disassemble
the Docking Station or the chargers. Doing so will void your
warranty.
Cleaning tips
Turn off the handset and unplug the Docking Station and chargers
before you clean them. Never immerse either in water. Clean the
exterior surfaces, including the charging contacts, with a cloth that
has been slightly moistened with water. Take care not to exert
undue pressure on charger electrical contacts while wiping.
Wiping the handset and Docking Station surface with a water-
dampened cloth or paper towel will remove most films or residues.
If the soiling is too stubborn for plain water, a mild detergent
solution may be used. Be sure to wipe away any detergent residue
with a clean water-dampened cloth.
The handset and Docking Station may be cleaned with any general-
purpose household glass and surface-type cleaner. DO NOT
SPRAY THE HANDSET DIRECTLY!
Pre-treated cloths such as used for eyeglasses or cameras may be
used to clean the handset and Docking Station. Pre-moistened
towelettes may also be used to clean the handset, however, avoid
those containing lanolin or aloe as it will leave a slippery residue.
The surface of the handset and Docking Station may be cleaned
occasionally with disinfectants used for general cleaning in a medical
environment. Isopropyl alcohol may be used occasionally applied
by a damp cloth or paper towel. When using alcohol, do not rub
the keypad characters vigorously. Doing so will significantly
degrade legibility.
Do not use furniture polishes, waxes or plasticizer-based cleaner
(Armor All™, etc.)
Do not use lanolin, aloe, glycerin or other skin care type products.
Do not apply any solvent such as acetone, mineral spirits etc.
Do not directly spray or immerse the handset.
Headset cleaning
Should the headset connector become dirty, a scratchy or
intermittent signal may be experienced. To clean the connector, dip
the non-padded end of either a wooden or paper handled cotton
swab in isopropyl alcohol. Gently insert in the connector and twist,
repeating several times. If available, blow compressed air into the
connector to clear debris.