Polycom 72-1004-01 Telephone User Manual


 
SpectraLink Corporation NetLink e340/h340/i640 Wireless Telephones and Accessories User Guide
Part Number: 72-1004-01-J.doc
Page 33
To place the Battery Pack into the NetLink h340 Wireless
Telephone, slide the lip of the Battery Pack into the bottom of the
cavity. Push the top of the Battery Pack until it snaps into place.
You should not have to force it against the handset.
Note for Argentina
Power adaptors will not be supplied for products shipped to
Argentina. Power adaptors must be obtained within the country.
Therefore for Argentina, the following applies:
Only certified power adaptors with the following electrical
characteristic shall be used. The use of different adaptors could
damage the device, present hazards to the user, and declare the
product warranty void.
Input rating: 220 VAC, 50/60 Hz
Output rating: 12VDC, 2A
(With less than 1V peak to peak ripple at 2 amps)
Output cable should not be any longer than two meters.
Output plug must be the following dimensions (5.5 x 2.1 x 8 to
11 mm).
The center pin of the DC output plug must be positive voltage.
The outer shell of the DC output plug must be negative.