Filter
Top Products
# When a subwoofer is connected to the rear
output, select S.W (subwoofer).
# When the rear output setting is S.W, you can-
not operate the following procedure.
3 Touch c or d next to PREOUT to switch
the subwoofer output or rear output.
Touching c or d will switch between S.W and
REAR and that status will be displayed.
Notes
! Even if you change this setting, there is no
output unless you turn the subwoofer output
on (refer to Using subwoofer output on page
36).
! If you change this setting, subwoofer output
in the audio menu will return to the factory
settings.
! Both rear speaker lead outputs and RCA rear
output are switched simultaneously in this
setting.
Changing languages for CAUTION
Some operations on this unit are prohibited
while driving or needs to be paid a careful at-
tention when operating. In such case, a cau-
tion appears on the display. You can change
the language of the cautions at this setting.
% Touch CAUTION LANGUAGE on the in-
itial menu to select your desired language.
Each time you touch CAUTION LANGUAGE it
selects languages for CAUTION in the follow-
ing order:
ENGLISH—ESPAÑOL—FRANÇAIS
Switching the sound muting/
attenuation
Sound from this system is muted or attenu-
ated automatically when the signal from the
equipment with mute function is received.
! Sound from this system returns to normal
when the muting or attenuation is can-
celed.
% Touch TEL to select any of the muting,
attenuation or off.
Touch TEL until the desired setting appears in
the display.
! MUTE – Muting
! ATT-20dB – Attenuation (ATT-20dB has a
stronger effect than ATT-10dB)
! ATT-10dB – Attenuation
! OFF – Turn the sound muting/attenuation
off
Notes
! The sound is turned off, MUTE is displayed
and no audio adjustments are possible.
! The sound is attenuated, ATT is displayed and
no audio adjustments, except volume control,
are possible.
! Operation returns to normal when the phone
connection is ended.
Switching the warning tone
If the front panel is not detached from the
head unit within four seconds of turning off
the ignition, a warning tone sounds. You can
turn off the warning tone.
1 Touch NEXT on the initial menu.
2 Touch DT.WARNING to turn warning
tone on.
# To turn warning tone off, touch DT.WARNING
again.
Entering PIN code for Bluetooth
wireless connection
To connect your cellular phone to this unit via
Bluetooth wireless technology, you need to
enter PIN code on your phone to verify the
connection. The default code is 0000, but you
can change this in this function.
! With some Bluetooth audio players, you
may be required to enter the Bluetooth
audio player PIN code in advance to set
this unit for a connection.
<
CRB2972-A/N>43
Operating this unit
En
43
Section
03
Operating this unit