Filter
Top Products
This equipment has been tested and found to
comply with the limits for a Class b digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation.
This equipment generates, uses,and can radiate
radio frequency energy and, if not installed and
used in accordance with the instructions, may
cause harmful interference to radio
communications. However, there is no guarantee
that interference will not occur in a particular
installation.
If this equipment does cause harmful
interference to radio or television reception,
which can be determined by turning the
equipment off and on, the user is encouraged to
try to correct the interference by one or more
of the following measures :
• Reorient or relocate the receiving antenna
(that is, the antenna for radio or television
that is “receiving” the interference).
• Reorient or relocate and increase the
separation between the telecommunications
equipment and receiving antenna.
• Connect the telecommunications equipment
into an outlet on a circuit different from
that to which the receiving antenna is
connected.
If these measures do not eliminate the
interference, please consult your dealer or an
experienced radio / television technician for
additional suggestions.Also,the Federal
Communications Commission has prepared a
helpful booklet,“How To Identify and Resolve
Radio/TV Interference Problems”.This booklet
is available from the U.S. Government Printing
Office,Washington, D.C. 20402.
Please specify stock number 004-000-00345-4
when ordering copies.
Noise
Electrical pulse noise is present at one time or
another.This is most intense during electrical
storms. Certain kinds of electrical equipment,
such as light dimmers, fluorescent bulbs, motors,
fans, etc., also generate pulse noise. Because
radio frequencies are susceptible to this, you
may on occasion hear pulse noise through the
receiver.This is usually only a minor annoyance
and should not be interpreted as a defect of the
unit.
FCC RF Radiation Exposure Statement
This equipment complies with FCC RF radiation
exposure limits set forth for an uncontrolled
environment.This equipment should be installed
and operated with a minimum distance of
20 centimeters between the radiator and your
body.This transmitter must not be co-located
or operating in conjunction with any other
antenna or transmitter.
For hand held operation, this phone has been
tested and meets the FCC RF exposure
guidelines. Use of other accessories may not
ensure compliance with FCC RF exposure
guidelines.
Hearing Aid Compatibility (HAC)
This telephone system meets FCC and Industry
Canada standards for Hearing Aid Compatibility.
Privacy
Privacy of communications may not be ensured
when using this telephone.
Additional Information
I.C. Notice
Terminal Equipment
NOTICE :This equipment meets the applicable
Industry Canada Terminal Equipment Technical
Specifications.
This is confirmed by the registration number.
The abbreviation, IC, before the registration
number signifies that registration was
performed based on a Declaration of
Conformity indicating that Industry Canada
technical specifications were met. It does not
imply that Industry Canada approved the
equipment.
NOTICE :The Ringer Equivalence Number
(REN) for this terminal equipment is marked on
the equipment itself.The REN assigned to each
terminal equipment provides an indication of
the maximum number of terminals allowed to
FCC and IC statements
42