Filter
Top Products
26
Introduction and Installation
To attach the power cable
LWhile pressing on the button with a pointed object such as a screwdriver, insert the power
cable into the terminal.
LTo disconnect the power cable, press on the button while pulling out.
LTo attach an optional power cable, cut off about 12 mm of the cable cover (1), then push
in firmly until the end of the cable is securely inserted into the power connection terminal
(2).
To attach the wires
LStrip off of the wire cover so that about 9 mm of the wire is exposed.
LWhile pressing on the button with a pointed object such as a screwdriver, insert the wire into
the terminal connector.
LTo disconnect a wire, press on the button while pulling out.
Monitor station DC terminal
12 Power cable cross section
Button
Terminal connector
Button
Terminal
connector
12 mm
Correct Incorrect
Button
Terminal connector
G201CE(E).book Page 26 Friday, November 11, 2005 4:46 PM