Filter
Top Products
24
Introduction and Installation
To attach the AC adaptor and the DC terminal to a wall
By placing the AC adaptor and the DC terminal in the case and mounting the case to the wall,
you can protect the AC adaptor and the DC terminal from tampering and exposure.
Note:
LDisconnect the DC cord from the clamp on the rear of the DC terminal beforehand. See
step 7 on page 23 for details.
LTake out the cardboard and wood screws from the AC case beforehand.
1 Attach the rear part of the case to a wall using the wood screws (4 mm x 16 mm).
2 Pack the AC adaptor and DC terminal as shown.
1. Pack the AC adaptor in the rear case.
LBe sure to run the power cord through the power cord hole.
2. Pack the DC cord in the rear case.
LBe sure to bundle the DC cord so that it will not touch the bottom of the case.
3. Pack the DC terminal in the rear case.
LBe sure to run the wires through the wire hole, then under the wire rib.
Wall
Case
83.5 mm
Wood screws
Wire rib
Wire hole
Power cord hole
Power cord
3 DC terminal
2 DC cord
1 AC adaptor
G201CE(E).book Page 24 Friday, November 11, 2005 4:46 PM