Filter
Top Products
20
Introduction and Installation
Installing the monitor station
Note:
LWhen connecting to a PBX, make sure the {PBX MODE} switch is set to {ON} before
installing the monitor station (page 28).
1 Install the mounting bracket to a wall using the wood screws (4 mm x 16 mm).
LRemove the mounting bracket from the rear of the monitor station beforehand.
LBefore drilling, see page 13 for installation location.
2 Attach the power cable to the terminal. See page 26 for details on how to attach the power
cable.
LIf you want to use your own power cable, see page 15 for the type and distance.
Wall
Wire (Not included)
Mounting bracket
83.5 mm
Wood screws
Terminal (Non polar)
Power cable
G201CE(E).book Page 20 Friday, November 11, 2005 4:46 PM