Filter
Top Products
16
Introduction and Installation
Installing the door station
Make sure to install the door station on a flat, vertical wall.
Important:
LOn the bottom surface of the door station, there is a hole to allow water to drain. Do
not cover it up when installing.
1 Unscrew the hex-head screw using the longer end of the allen key and remove the
mounting bracket from the rear of the door station.
LThe pin hole camera is not a screw to be touched or removed.
Hex-head screw
(Attached to the door station)
Allen key
Mounting bracket
Pin hole camera
G201CE(E).book Page 16 Friday, November 11, 2005 4:46 PM