Filter
Top Products
17
Introduction and Installation
2 Attach the mounting bracket to the wall using the wood screws (3.8 mm x 20 mm).
LBefore drilling, see page 13 for installation location.
3 Connect the wires that connect to the monitor station to the terminal connector by
unscrewing the screws, pushing in the wires, then tightly fastening the screws.
LSee page 15 for the wire type and distance.
LYou can change the camera angle using the camera angle control lever. See page 13 for
details.
Wall
Mounting bracket
83.5 mm
Wire (Not included)
Wood screws
Camera angle control lever
Wire (Not included)
Terminal connector
(Non polar)
Screw
G201CE(E).book Page 17 Friday, November 11, 2005 4:46 PM