Filter
Top Products
Make sure the unit is not being used and the handset is lifted off the
base unit.
1
Press (PROGRAM).
•The TALK/MUTE indicator flashes.
2
Press (FLASH/CALL!WAIT/PLAYBACK).
•“P” is displayed on the base unit.
3
Press (0).
•“Set time” is announced from the
base unit. If previously adjusted, the
day/time will be heard.
4
Enter the current time (hour and
minute) using a 4-digit number.
(Ex. To set 9:30, enter “0930”.)
•The 2 digits of the entered number is
displayed.
5
Press (*) to select “AM” or “PM”.
Press (#) repeatedly to set the day.
6
Press (PROGRAM).
•The base unit announces the
day/time. The clock starts working.
•If 6 beeps sounds from the base
unit, the setting is not correct. Start
again from the beginning.
•You can exit the programming mode any time by pressing (OFF)
.
•In step 4, you cannot enter numbers greater than 12. Do not use military time.
(To set 13:00 hours, enter “0100” and select “PM” by pressing (*).)
18
Day and Time
Voice Day/Time Stamp: During playback, a synthesized voice will
announce the day and time that each message was recorded.
If a power failure occurs, the time may be shifted. When “ ” flashes
on the base unit display, reprogram the current day/time.
To check the day/time
Press (PROGRAM) \ (FLASH/CALL!WAIT/PLAYBACK) \ (0).
•
The base unit announces the current day/time. When finished, press
(OFF)
.
(PROGRAM)
(OFF)
(FLASH/CALL!WAIT/PLAYBACK)
TALK/MUTE
Indicator
Preparing the Answering System