Filter
Top Products
Important Safety Instructions
When using telephone equipment, basic safety precautions should always be followed to reduce the risk of
fire, electric shock and injury to persons, including the following:
• Follow all product warnings, cautions, and instructions.
• Read all the information contained in this manual.
• Close and secure the front cover when the unit is in operation.
• This unit is equipped with a 3-wire grounding plug. The plug will only fit into a grounded power outlet. Do
not modify this plug in any way. If it cannot be inserted into the outlet, have the outlet replaced by a licensed
electrician.
• This unit is designed to operate at one specific voltage and current setting. The proper voltage and current
required for this unit are listed on the product label.
• Do not overload wall outlets. Overloaded outlets could result in fire and/or electrical shock.
• Use only the AC cord included with the unit when connecting the AC adaptor to the power outlet.
• Install the unit so that the AC cord is not obstructed in any way. Do not connect the unit to an extension
cord.
• Before touching any internal components, turn off the unit, disconnect the AC adaptor, and wait at least
20 seconds.
• Unplug the AC adaptor before cleaning the unit.
• Do not use solvents, liquid cleaners, water, or abrasive powders to clean the unit. Use only a damp soft
cloth for cleaning.
• Do not expose the unit to dust, moisture, condensation, high temperatures (more than 40 °C [104 °F]),
vibration, and direct sunlight.
• Mount the unit on a stable wall surface. Do not mount the unit inside of a separate enclosure unless it is
properly ventilated.
• Mount the unit on a surface that is flat and free of obstructions, so that the openings on the back of the unit
will not be blocked.
• Do not block the vent slots and openings located on all sides of the unit. Allow at least 20 cm (8 in) of space
above and 10 cm (4 in) on the sides of the unit.
• Do not install the unit near water or moisture, heating appliances, or electrical noise generating devices
such as televisions, monitors, fluorescent lamps, or electric motors.
• Handle the unit carefully. Do not drop or otherwise expose the unit to physical shock.
• Do not insert wires, pins, or any other material into the unit’s vent slots or access points. This could result
in electrical shock and serious unit malfunction.
• If the unit malfunctions, disconnect the unit from the telephone line and check the line by reconnecting the
telephone. If the telephone operates properly, have the unit repaired by a Panasonic Factory Service
Technician.
• Do not disassemble this product. Dangerous electrical shock could result. The unit must only be
disassembled and repaired by a Panasonic Factory Service Technician.
• Unplug and transport the unit to a service technician if the AC adaptor or AC cord is frayed or damaged,
if the cabinet is cracked or broken, or if the unit has been exposed to moisture, has been dropped, or is
not otherwise operating properly.
• Do not use the telephone during a lightning storm or to report a gas leak in the vicinity of the leak.
• The lines connecting the PBX and VPS must never run outside of the building.
• This product is only for connection behind a suitable PBX and should not be connected directly to the
network.
Document Version 3.0 2010/06 Installation Manual 3
Important Safety Instructions