Filter
Top Products
31
Problem
You cannot operate the
answering system from a
touch tone phone.
While recording a greeting
message, a telephone
connected to the same line
starts to ring and stops
recording.
During playback, a telephone
connected to the same line
starts to ring and stops
playback.
Remedy
≥Make sure to enter the correct remote
code.
≥The answering system may not
respond if the tones are too short to
activate the unit. Press each button
firmly.
≥The answering system is off. Turn it
on (p. 29).
≥To answer the call, lift the handset.
The recording will stop. Start again
from the beginning after hanging up.
≥To answer the call, lift the handset.
To resume playback, press
(NEW\MESSAGE) after hanging up.
30
Before Requesting Help
Remedy
≥Check the settings (p. 7–12).
≥Unplug the AC adaptor to reset.
Plug in and try again.
≥Do not pause for over 60 seconds
while programming.
≥To answer the call, lift the handset.
Start again from the beginning after
hanging up.
≥If the caller is not stored in the Caller
List, the unit will not display the caller’s
information.
≥Do not pause for over 60 seconds
while searching.
≥Press VOLUME/SEARCH
(^) to
increase volume.
≥If a power failure occurs, programmed
information may be erased.
Reprogram if necessary.
≥Memory is full. Erase some, or all, of
the messages (p. 17).
≥Memory is full. Erase some, or all, of
the messages (p. 17).
Problem
The unit does not work.
You cannot program function
items, such as the dialling
mode.
While programming or
searching, a telephone
connected to the same line
starts to ring and stops the
program/search.
The unit does not display the
caller’s phone number whose
message is being played.
The display goes to the
stand-by mode while viewing
the Caller List.
During message playback or
monitoring a call, no sound is
heard.
Previously programmed
information is erased.
The answering system is on,
but incoming messages are
not recorded.
“Message full” is
displayed, the ANSWER
indicator flashes rapidly, and
no new messages are
recorded.
PQQX12356ZA-BM 01.3.22 3:56 PM y[W 30