Error messages
Display message Cause/solution
Busy
R T
he called unit is in use.
R Other units are in use and the system is busy. Try again later.
R Privacy mode is on for the call you tried to join (page 17).
R The handset you are using is too far from the base unit. Move
closer and try again.
Check tel line 1
C
heck tel line 2
R The supplied telephone line cord has not been connected yet or
not connected properly. Check the connections (page 8).
R If you use the unit as a single-line telephone only, erase the
message as follows:
To erase “Check tel line 1”, press MMENUN. a #189
To erase “Check tel line 2”, press MMENUN. a #190
When a power failure occurs, the message is displayed again.
Erase again as above.
Error!!
R R
ecording was too short. Try again.
Failed
R P
honebook copy failed (page 25). Confirm the other unit (the
receiver) is in standby mode and try again.
Incomplete
R P
honebook copy is incomplete. The receiver’s phonebook
memory is full. Erase the unwanted phonebook entries (page 24)
from the other unit (the receiver) and try again.
Memory full
R T
he phonebook memory is full. Erase unwanted entries (page 24).
R Message memory is full. Erase unwanted messages (page 36,
37).
Messages full
R M
essage memory is full. Erase unwanted messages (page 36,
37).
No link to base.
R
econnect AC adaptor.
R T
he handset has lost communication with the base unit. Move
closer to the base unit and try again.
R Unplug the base unit’s AC adaptor to reset the unit. Reconnect
the adaptor and try again.
R The handset’s registration may have been canceled. Re-register
the handset (page 31).
Use rechargeable
b
attery.
R A
wrong type of battery such as Alkaline or Manganese was
inserted. Use only the rechargeable Ni-MH batteries noted on
page 4,6.
You must first
s
ubscribe to Caller ID.
R Y
ou must subscribe to a Caller ID service. Once you receive
caller information after subscribing to a Caller ID service, this
message will not be displayed.
For assistance, please visit http://www.panasonic.com/help
45
Useful Information