Filter
Top Products
Useful Information
41
Programmable settings
Battery recharge
I do not know how to erase y
(Missed call) from the display.
L There are unviewed missed calls remaining.
View them using the following method.
1 K (centre of joystick) ijiM
2 Push the joystick down to search from the
most recent call, or push the joystick up to
search from the oldest call.
Problem Cause/solution
I have changed the display
language to a language I
cannot read.
L Change the display language (page 14).
While programming, the
handset starts to ring.
L A call is being received. Answer the call and
start again after hanging up.
While programming, the
display returns to standby
mode.
L A call matching an entry in the bar call list is
being received. Wait and try again later.
I cannot register a handset to a
base unit.
L The maximum number of base units (4) is
already registered to the handset. Cancel
unused base unit registrations from the
handset (page 30).
L The maximum number of handsets (6) is
already registered to the base unit. Cancel
unused handset registrations from the base
unit (page 29).
L You entered the wrong PIN. If you forget your
PIN, contact your nearest Panasonic service
centre.
L Place the handset and the base unit away
from other electrical appliances.
Problem Cause/solution
The handset beeps and/or )
flashes.
L Battery charge is low. Fully charge the
batteries (page 13).
I fully charged the batteries, but
) still flashes.
L Clean the charge contacts and charge again
(page 13).
L It is time to replace the batteries (page 12).
I fully charged the batteries, but
the operating time seems to be
shorter.
L Clean the battery ends (S, T) and the
charge contacts with a dry cloth, and charge
again.
Problem Cause/solution