Filter
Top Products
Programming
30
Note:
L Calls are disconnected when the
handset moves from one radio cell to
another.
Registering a handset to a
base unit
The supplied handset and base unit are
pre-registered. If for some reason the
handset is not registered to the base unit
(for example, _ is displayed even when
the handset is near the base unit), re-
register the handset.
1 Handset:
1 i {#}{1}{3}{0}
2 {V}/{^}: Select a base unit number.
i M
L This number is used by the
handset as a reference only.
3 Base unit:
Proceed with the operation for your
model.
■ KX-TG7511
Press and hold {x} for about 5
seconds. (No registration tone)
■ KX-TG7521
Press and hold {x} for about 5
seconds, until the registration
tone sounds.
L If all registered handsets start
ringing, press the same button to
stop. Then repeat this step.
L The next step must be completed
within 90 seconds.
4 Handset:
Wait until “Base PIN” is displayed.
i Enter the base unit PIN (default:
“0000”). i M
L If you forget your PIN, contact an
authorised service centre.
L When the handset has been
registered successfully, w is
displayed.
Selecting a base unit
When “Auto” is selected, the handset
automatically uses any available base
unit it is registered to. When a specific
base unit is selected, the handset makes
and receives calls using that base unit
only. If the handset is out of range of that
base unit, no calls can be made.
1 1i {#}{1}{3}{7}
2 {V}/{^}: Select the desired base
unit number, or “Auto”. i M
L The handset starts searching for
the base unit.
Deregistering a handset
A handset can cancel its own
registration that is stored to the base
unit. This allows the handset to end its
wireless connection with the system.
1 1 i {#}{1}{3}{1}
2 {V}/{^}: Select the handset you
want to cancel. i M
3 {V}/{^}: “Yes” i M
L A confirmation tone sounds.
L The handset does not beep when
cancelling its own registration.
4 {ic}
Cancelling a base unit
A handset can cancel a base unit that it
is registered to. This allows the base unit
to end its wireless connection with the
system.
1 1 i {#}{1}{3}{9}
2 {V}/{^}: Select the base unit you
want to cancel. i M
3 {V}/{^}: “Yes” i M i {ic}
Note:
L To register a handset to another base
unit or to the same base unit again,
see page 30.
TG7511_7521BX(e).book Page 30 Tuesday, June 15, 2010 2:10 PM