Filter
Top Products
Programmable Settings
For assistance, please visit http://www.panasonic.com/consumersupport 33
Programming via direct commands
You can also program features using “direct commands”—special codes that take you
directly to the feature you wish to program and allow you to select the desired setting.
There is no need to scroll through the unit’s menus.
Details of each feature can be found on the corresponding pages.
Important:
LBefore programming, make sure the handset and base unit are not being used. The
handset must be operated near the base unit and while off the base unit.
1 Press {MENU} (middle soft key), then press {#}.
2 Enter the desired feature code (shown below).
3 Enter the desired setting code (shown below).
LThis step may vary depending on the feature being programmed.
4 Press {SAVE}.
5 Press {OFF} to exit programming mode.
Note:
LIf the handset beeps 3 times, you entered an invalid code. Enter the correct code.
LIf you make a mistake or enter the wrong code, press {OFF} then start again by
pressing {MENU}.
Direct commands chart
Important:
LThe default settings are indicated by *.
Feature Feature code Setting code Page
Date and time {1}{0}{1} Enter date and time.
(Default: 12.31.2005)
18
Change language {1}{1}{0}{1}: English* {2}: Spanish 41
Set dial mode {1}{2}{0}{1}: Pulse {2}: Tone* 18
Set flash time {1}{2}{1}{1}: 700 ms* {2}: 600 ms
{3}: 400 ms {4}: 300 ms
{5}: 250 ms {6}: 110 ms
{7}: 100 ms {8}: 90 ms
41
Set line mode {1}{2}{2}{1}: A {2}: B* 42
Registration {1}{3}{0} Go to step 4 on page 43. 43
Enter direct No.
: