Filter
Top Products
Useful Information
20
Liquid damage
Caution:
L To avoid permanent damage, do not use a microwave oven to speed up
the drying process.
Registering the handset to the base unit
1 {j/OK}
2 {v}/{e}: “SETTING HS” i {>}
3 {v}/{e}: “REGISTRATION” i {>}
4 {v}/{e}: “REGISTER HS” i {>}
5 Press and hold {x} on the base unit for about 5 seconds.
L If all registered handsets start ringing, press {x} to stop, then start
again from step 1.
L The rest of the procedure must be completed within 4 minutes.
6 {v}/{e}: Select a base unit number. i {>}
7 Wait until “BS PIN” is displayed. i Enter the base unit PIN (default:
“0000”). i {>}
Caller information is not
displayed.
L You must subscribe to a Caller ID
service. Contact your service provider/
telephone company for details.
L If your unit is connected to any
additional telephone equipment,
remove and plug the unit directly into
the wall jack.
L If you use a DSL/ADSL service, we
recommend connecting a DSL/ADSL
filter between the base unit and the
telephone line jack. Contact your DSL/
ADSL provider for details.
L Other telephone equipment may be
interfering with this unit. Disconnect the
other equipment and try again.
Caller information is slow
to display.
L Depending on your service provider/
telephone company, the unit may
display the caller’s information at 2nd
ring or later.
L Move closer to the base unit.
I cannot remember the
PIN.
L Change the PIN using the instructions
on page 21.
Problem Cause/solution
Problem Cause/solution
Liquid or other form of
moisture has entered the
handset/base unit.
L Disconnect the AC adaptor and
telephone line cord from the base unit.
Remove the batteries from the handset
and leave to dry for at least 3 days.
After the handset/base unit are
completely dry, reconnect the AC
adaptor and telephone line cord. Insert
the batteries and charge fully before
use. If the unit does not work properly,
contact your nearest Panasonic service
centre.
TG1311_1312_1313BX(e).book Page 20 Tuesday, September 2, 2008 10:36 AM