Filter
Top Products
18
Useful Information
Transferring calls, conference calls
Outside calls can be transferred between 2 handsets. 2 handsets can have
a conference call with an outside party.
Example: When handset 1 transfers a call to handset 2
1 Handset 1:
During an outside call, press {INT}. i Press {2} (desired handset
number).
L The outside call is put on hold.
L If there is no answer, press {INT} to return to the outside call.
2 Handset 2:
Press {C} to answer the page.
L Handset 2 can talk with handset 1.
3 Handset 1:
To complete the call transfer, press {ih}.
To establish a conference call, press {3}.
Transferring a call without speaking to the other handset user
1 During an outside call, press {INT}. i Enter the desired handset
number.
L k flashes to indicate the outside call is on hold.
2 {ih}
L The outside call rings at the other handset.
Note:
L If the other handset user does not answer the call within 30 seconds, the
call rings at your handset again.
Useful Information
Troubleshooting
If you still have difficulties after following the instructions in this section,
disconnect the base unit’s AC adaptor and turn off the handset, then
reconnect the base unit’s AC adaptor and turn on the handset.
Available for:
KX-TG1312/KX-TG1313
Problem Cause/solution
w is flashing. L The handset is too far from the base
unit. Move closer.
L The base unit’s AC adaptor is not
connected. Check the connections
(page 4).
L You are using the handset or base unit
in an area with high electrical
interference. Re-position the base unit
and use the handset away from
sources of interference.
L The handset registration is cancelled.
Register the handset to the base unit
(page 20).
TG1311_1312_1313BX(e).book Page 18 Tuesday, September 2, 2008 10:36 AM