Filter
Top Products
1.7 Setting the Telephone According to Your Needs
96 User Manual
1.7.2 Refusing Incoming Calls (Do Not Disturb [DND])
You may set this feature when you are in a meeting or busy.
To set/cancel
• When using a proprietary telephone, you can set or cancel Do Not Disturb by pressing the
FWD/DND button (fixed button) instead of " 710".
• The FWD/DND button light shows the current status as follows:
Off: Both features are not set.
Red on: FWD mode
Flashing red slowly: DND mode
• The system has two modes: (1) FWD/DND Cycle Switch Mode and (2) FWD/DND Setting
Mode. Ask your manager what mode your system is in if you are not sure.
(1) When in the FWD/DND Cycle Switch Mode:
Pressing the FWD/DND button (fixed button) while in idle status will cycle the setting
as shown below:
(2) When in the FWD/DND Setting Mode:
Pressing the FWD/DND button (fixed button) while in idle status will take you directly
to the programming mode for the FWD/DND setting.
(Refer to "3.1.2 Settings on the Programming Mode".)
Note
A FWD/DND button (customised button) is always in FWD/DND Cycle Switch Mode: the
mode cannot be changed.
• If your extension has set this feature, a calling extension will hear DND tone.
• If this feature is set, the Call Forwarding (FWD) feature does not work.
• Specified extensions can override this feature and call DND extensions (DND Override).
On-hook.
Enter 1 to set
or 0 to cancel.
PT/SLT/PS
Set
Cancel
1
0
OR
Off-hook.
Enter 71.
1
2
0
Both Calls
Intercom Calls
Outside Calls
OR
OR
17
Enter 0 to 2 as you desire.
C.Tone
FWD DND Off