77
Useful Information
Problem
While programming or
searching, the unit starts to
ring and stops the
program/search.
The display goes to the
standby mode while
viewing the Caller
List/directory list.
The unit does not display
the caller’s phone number.
(LOCATOR/INTERCOM)
does not function.
You cannot redial the last
number dialled.
Remedy
• To answer the call, lift the handset or
press (TALK) or (SP-PHONE).
Start again from the beginning after
hanging up.
• Do not pause for over 60 seconds while
searching.
• Other telephone equipment may be
interfering with your phone. Disconnect it
and try again.
• Other electrical appliances connected to
the same outlet may be interfering with
the Caller ID information.
• Telephone line noise may be affecting
the Caller ID information.
• Some PABX do not support Caller ID
services.
• The portable unit is too far from the base
unit.
• The portable unit is engaged in an
outside call. Wait until the IN USE
indicator light goes out.
• The portable unit number has been
cleared or has not been registered.
Register the portable unit number (p. 66).
• If the last number dialled was more than
32 digits long, the number will not be
redialled.
• (REDIAL/PAUSE) has a double function
as either redial or pause. It will redial the
last number dialled, if pressed at the
outset of a call (p. 21, 24).
If another number has been dialled first,
it will operate as a pause button (p. 62).