Filter
Top Products
Before Requesting Help
39
Useful Information
Problem
“Out of range” is displayed
and an alarm tone sounds.
The unit does not work.
Static, sound cuts in/out,
fades. Interference from other
electrical units.
The handset does not ring.
The handset display is blank
even after pressing , ,
or OK.
Remedy
• You are too far from the base unit.
Move closer and try again.
• Place the handset on the base unit and
try again.
• Plug in the AC adaptor.
• Extend the antennas fully.
• Check the settings (p. 8–10).
• Charge the battery fully (p. 9).
• Clean the charge contacts and charge
again (p. 10).
• Install the battery properly (p. 9).
• Place the handset on the base unit and
unplug the AC adaptor to reset.
Plug in, and try again.
• Re-install the handset battery within
3 minutes to avoid memory loss and
place the handset on the base unit.
Then try again.
• This unit is not designed to be used
with rotary (pulse dialling) services.
• Locate the handset and the base unit
away from other electrical appliances
(p. 3).
• Move closer to the base unit.
• Extend the antennas fully.
• Press
(EXIT/CH) to select a clearer
channel.
• The ringer volume is set to OFF.
Set to HIGH or LOW (p. 12).
• Charge the battery fully (p. 9).