Filter
Top Products
Other programming
Changing the handset name
E
ach handset can be given a customized
name (“Bob”, “Kitchen”, etc.). This is useful
when you make intercom calls between
handsets. You can also select whether or not
the handset name is displayed in standby
mode. The default setting is “No”. If you select
“Yes” without entering any handset name,
“Handset 1” to “Handset 6” is displayed.
1 MMenuN (right soft key) #104
2 Enter the desired name (max. 10
characters).
3 MSaveN
4 MbN: Select the desired setting. a
MSelectN 2 times a MOFFN
Calendar/Schedule
Y
ou can program 20 schedule alarms for each
handset using the calendar. A schedule alarm
sounds at the set time for 1 minute. A text
memo can also be displayed for the schedule
alarm.
Important:
R Make sure the unit’s date and time setting
is correct (page 12).
Adding a new entry
1 MM
enuN (right soft key) a
a
MS
electN
2 MbN: Select the desired date. a MSelectN
3 MMenuN a MbN: “Add new entry” a
MSelectN
4 Edit the date if necessary. a MOKN
5 Set the desired time. a MOKN
6 Enter a text memo (30 characters max.;
page 17). a MOKN
7 MbN: Select the desired alarm tone. a
MSelectN 2 times
R You can select “Off” if you prefer not
to hear an alarm tone.
R W
e recommend selecting a different
ringer tone from the one used for
outside calls.
8 MOFFN
Note:
R To stop the alarm, press MStopN or place
the handset on the base unit or charger.
R When the handset is in use, the alarm will
not sound until the handset is in standby
mode.
Viewing entries
1 MM
enuN (right soft key) a
a
MS
electN
2 To see the entries on the selected date,
press MSelectN.
To see the schedule list, press MListN.
R You can see detailed information
about the schedule by pressing
MMenuN. a MbN: “Detail” a
MSelectN
Editing an entry
1 MMenuN (right soft key) a a
MS
electN
2 MListN a MbN: Select the desired entry.
3 MMenuN a MbN: “Edit” a MSelectN
4 Edit the date if necessary. a MOKN
5 Edit the time if necessary. a MOKN
6 Edit the text memo if necessary (30
characters max.). a MOKN
7 MbN: Select the desired alarm tone. a
MSelectN 2 times a MOFFN
Erasing an entry
S
chedule alarm entries are not erased
automatically after the schedule alarm sounds.
Erase unwanted entries.
1 MMenuN (right soft key) a
a
MS
electN
2 MListN a MbN: Select the desired entry.
3 MMenuN a MbN: “Erase” a MSelectN
4 MbN: “Yes” a MSelectN a MOFFN
For assistance, please visit http://www.panasonic.com/help
31
Programming
PRS120(en)_0122_ver110.pdf 31 2014/01/22 10:09:31