Filter
Top Products
4 *:
Select “AM” or “PM”. a MOKN
5 Enter the desired hour and minute you
wish to end this feature.
6 *: Select “AM” or “PM”.
7 MSaveN a MOFFN
Changing the start and end time
1 MM
enuN (right soft key) #237
2 Continue from step 3, “Turning silent
mode on/off”, page 27.
Selecting groups to bypass silent
m
ode
1 MMenuN (right soft key) #241
2 Select your desired groups by pressing
1 to 9.
R “
” is displayed next to the selected
group numbers.
R To cancel a selected group, press the
same dial key again. “
” disappears.
3 MS
aveN a MOFFN
Call block
T
his feature allows the unit to reject calls when:
– the unit receives a call from a phone
number stored in the call block list as
unwanted (“Storing unwanted callers”,
page 28).
– the unit receives a call without phone
number (“Blocking incoming calls without
phone number”, page 28).
When a call is received, the unit rings for a
short time
*1
while the caller is being identified.
If the phone number matches an entry in the
call block list, the unit emits no sound to the
caller, and disconnects the call. (Caller ID
subscribers only)
*1 This is called first ring. If you do not want
the first ring to sound, turn this setting to
“Off” (page 29).
Important:
R When the unit receives a call from a
number that is stored in the call block list or
a call without a recognized phone number,
t
he call is logged in the caller list
(page 33) with
after the call is
d
isconnected.
Storing unwanted callers
You can store up to 100 phone numbers in the
call block list.
Important:
R You must store the phone number with an
area code in the call block list.
n From the caller list:
1 MCN CID
2 MbN: Select the entry to be blocked. a
MDetailN
R To edit the number: MMenuN a
MbN: “Edit” a MSelectN
Press MEditN repeatedly until the
phone number is shown in the
10-digit format. And then, press
MSaveN. Go to step 5.
3 MMenuN
4 MbN: “Save CID” a MSelectN
5 MbN: “Call block” a MSelectN
6 MbN: “Yes” a MSelectN
7 Edit the phone number if necessary
(24 digits max.).
8 MSaveN a MOFFN
n By entering phone numbers:
1 MMenuN (right soft key) #217
2 MMenuN a MbN: “Add” a MSelectN
3 Enter the phone number (24 digits
max.).
4 MSaveN a MOFFN
Blocking incoming calls without
p
hone number
You can reject a call when no phone number
is provided, such as a call just showing “Out
of area”.
1 MMenuN (right soft key) #240
2 MbN: Select the desired setting. a MSaveN
28
For assistance, please visit http://www.panasonic.com/help
Programming
PRS120(en)_0122_ver110.pdf 28 2014/01/22 10:09:31