Panasonic KX-TC1871NZB Answering Machine User Manual


 
91
Useful Information
Problem
The unit does not display the
caller’s phone number.
The handset display goes to
the standby mode while
viewing the Caller List.
When a second call is
received during a
conversation, the unit does
not display the new caller’s
phone number.
(LOCATOR/INTERCOM) does
not function.
You cannot redial by
pressing (REDIAL/PAUSE) or
(REDIAL).
You cannot have a
conversation using
the handset.
You cannot have a
conversation using
the headset.
Cause and Remedy
You do not subscribe to a Caller ID service.
Other telephone equipment may be
interfering with your phone. Disconnect
it and try again.
Other electrical appliances connected to
the same outlet may be interfering with
the Caller ID information.
Telephone line noise may be affecting
the Caller ID information.
Some PABX units do not support Caller
Display.
Do not pause for over 60 seconds while
searching.
(DIGITAL\SP-PHONE) was pressed.
The line mode selection is incorrect.
See page 17.
Your Caller ID service provider does not
support this feature.
The handset is too far from the base unit.
The handset is engaged in an outside
call or is viewing the Caller List/directory
list. Wait until the IN USE/CHARGE
indicator light goes out.
If the last number dialled was more than
32 digits long, the number will not be
redialled correctly.
Access numbers entered after pressing
(TONE) will not be included when
redialling.
When the optional headset is connected
(p. 86), you must use the headset to
talk with the caller. To have a normal
cordless phone conversation,
disconnect the headset.
Make sure that the optional headset is
connected properly (p. 86).
PQQX12877ZA-6 00.8.23 10:54 AM y[W 91