Filter
Top Products
10. Help
85
For Fax Advantage assistance, call 1-800-435-7329.
Static, sound cuts in/out,
fades. Interference from
other electrical units.
L Move the handset and the base unit away from other electrical
appliances.
L Move closer to the base unit.
L Raise the base unit antenna.
While programming, the
handset starts to ring.
L To answer a call, press {TALK} or {SP-PHONE}. Start again from
the beginning after hanging up.
I cannot redial by
pressing {REDIAL}.
L If the last number dialed was more than 48 digits long, the number
will not be redialed correctly.
“Recharge battery” is
displayed, 68879 flashes
or the handset beeps
intermittently.
L Fully charge the battery (page 20).
“Charge for 6h” and
68889 are displayed and
the handset does not
work.
L The battery has been discharged. Fully charge the battery (page
20).
I charged the battery fully,
but “Recharge battery”
is still displayed and/or
68879 continues to flash,
or “Charge for 6h” and
68889 are displayed.
L Clean the charge contacts and charge again (page 20).
L The battery may need to be replaced (page 17). If you install a new
battery, fully charge it (page 20).
The [CHARGE] indicator
does not go out after the
battery has been charged.
L This is normal.
I cannot receive
documents by pressing
{*}{#}{9} on the
handset.
L You must set remote fax activation to ON (feature #41 on page 72)
beforehand.
L Press {*}{#}{9} firmly.
L The memory is full of received documents due to a lack of
recording paper or a recording paper jam. Install paper or clear the
jammed paper.
The handset display is
blank.
L Fully charge the battery (page 20).
I cannot have a
conversation using the
headset.
L Make sure that an optional headset is connected properly (page
18).
L If “SP-phone” is displayed on the handset, press {TALK} to
switch to the headset.
I cannot program items. L Programming is not possible while the handset and/or base unit is
being used.
L Do not pause for over 1 minute while programming.
L Move closer to the base unit.
L While another user is listening to messages or the telephone
answering machine is answering a call, you cannot program. Try
again later.
Problem Cause & Solution
FPG379-PFQX2138ZA-en.book Page 85 Wednesday, January 12, 2005 4:49 PM