Filter
Top Products
Preparation
22
For product assistance, visit www.globarange.com
For A assistance, visit www.joip.com
Understanding the indicators on the base unit
TEL indicator/IP indicator
The TEL indicator and IP indicator show the status of the landline and IP line,
respectively, as follows.
*1 k When another phone uses the same landline, the TEL indicator lights.
STATUS indicator
During the startup process you may notice that the STATUS indicator on the base
unit is flashing. This indicates that the base unit is booting up with the A service.
You may find the following flash patterns helpful to you:
Status Meaning
Light off The line is available.
Light on The line is in use.
*1
Flashing rapidly A call is being received.
Flashing A call is put on hold.
The answering system is answering a call. (BB-
GT1540)
The IP indicator flashes when the base unit software is
being downloaded from the A service.
Status Meaning
Colour Light pattern
Green On L The base unit is connected to the Internet. The
startup process is complete and you may now
make and receive A internet calls.
Flashing L The base unit is downloading data from the A
service. Do not disconnect the Ethernet cable or
AC adaptor from the base unit until the STATUS
indicator stops flashing and lights in steady green.
Red On L When the base unit is turned on, the STATUS
indicator lights in red for about 3 seconds.
Flashing L The base unit is registering a handset.
Flashing
rapidly
L The base unit is paging handsets. (BB-
GT1500/BB-GT1502)
GT15xxC.book Page 22 Tuesday, July 24, 2007 7:17 PM