Oricom ECO700 Cordless Telephone User Manual


  Open as PDF
of 36
 
17
CORDLESS hANDSET OpERATION
Note:
Whenthekeypadislocked,[
]keyand[INT]keycan
be used to answer an external or intercom call.
Registration
Register new handsets on the eco70/700 base
The handsets which come in the same pack are already
registeredtothebase.Ifyoubuynewhandsets.Youneed
to register them before use.
1. Chargethebatteries(for14hours).
2. Registerthehandset(tothebaseunit).
the operation is different in eco70 and eco700.
Ineco70,weneedtosetthebaseunitinregistrationmode
by resetting the base power.
Ineco700,wecansetthebaseinregistrationmodeby
pressingandholdingthebase[
]for10s
Eachbasecanregisterupto5handsets.
Duringstandbymode,
1. Pressandholdthe[
]keyfor3secondsuntilboth
the[ ]and[ ]iconsash,thenpressandholdthe
[ ]keyfor3seconds.Thefollowingwillappearon
the display.
2. Press1andthehandsetbeginstosearchforthebase.
3. Enterthebasepincode(0000).Ifthepiniswrong,the
handset will restart searching for the base.
4. Whenthehandsetisregistered,itwillshow“HS”followed
by the handset number.
Note:
Ifthebaseisfullandcannotaddanymorehandsets,you
willhearatone.Seethenextsectiontoremoveahandset.
Remove handsets
Duringstandbymode,
1. Pressandholdthe[
]keyfor3seconds,thenpress
andholdthe[ ]keyfor3seconds.
2. Enterthe default value 0000.Ifthepiniswrong,the
handset will go back to standby.
3. Pressthenumerickeys(1-5)toenterthehandsetnumber
youwanttoremove.
4. The unit will go back tostandby if the removal is
successful.
Note:
Youcanonlyremoveotherhandsetsinyoursystembut
youarenotabletoremovethehandsetyouareusing.
 previous next