Filter
Top Products
Getting Started
10
1. Place the 2 rechargeable batteries
(included) into the battery
compartment.
2. Slide the battery door firmly into
place.
3. Place the handset on the base unit or
charger for charging.
CHECKING THE BATTERY LEVEL
The battery icon displays the current battery level.
= 100% full = 60% full = 30% full = Empty requires charging.
If you are on the phone while the battery is nearly flat, you will hear warning tones. Your call may be cut off
shortly after the warning.
WHAT IS STANDBY MODE?
Your phone is in standby mode when it is idle. The standby screen displays the handset name and
number, the signal icon, and the battery icon.
SETTING YOUR PHONE’S COUNTRY
If you have bought this phone in New Zealand you will need to select your country in order for it to work
properly according to your country’s standards. If you are in Australia you can skip this instruction as the
phone factory default is Australia.
1. After the phone is fully charged press during standby mode.
2. Enter the country code.
Country Code
AUSTRALIA 23
NEW ZEALAND 168
3. Press . Your phone is now ready to use.
CHECKING THE SIGNAL STRENGTH
The signal icon displays the link status between your handset and the base unit. A steady icon
means your handset and the base unit are linked. A flashing icon means your handset and the base
unit are not linked.
If you move too far away from the base unit while you are on the phone, you will hear warning tones
notifying you that your handset is almost out of range – lost link. Take your handset closer to the base
unit or your call may be cut off shortly after the warning.
NOTE
:
Handset may get warm during initial charge. This is normal. The handset
may take a few seconds to power up.