Filter
Top Products
8
Securing the Master Panel
1. Refer to Figure 20. Inspect all wiring connections to make
sure they are complete and correct.
2. Make sure all antenna connections are secure.
3. Position all Remote Speaker wires toward the LEFT-HAND
side of the wiring channel to prevent interference with the
unit’s heat sink.
4. Position Master panel over rough-in frame, and align screw
holes in Master panel with mounting brackets.
5. Secure Master panel to rough-in mounting brackets with
two screws (supplied).
NOTE: The screws will pierce the wall surface behind the
mounting brackets. If wall surface is hard, a clearence hole
must be drilled behind mounting brackets before securing
Master panel.
INSTALLATION
(Continued)
FIGURE 19