Filter
Top Products
Configuring Local Menu options
75
Note: Unless you need to dual pair a headset, operating the headset
with the 1140E is simpler if the headset is only used with its charging-
only base. The desktop IP Phone base should be powered off if it is
not in use.
Interaction with wired headsets
If you connect a Bluetooth wireless technology headset and a wired
headset to the same IP Phone 1140E, the “Use Bluetooth headset” item
switches between the wired headset and the Bluetooth headset. If you
select the “Use Bluetooth Headset” check box, the Bluetooth headset
provides the audio. If you clear the “Use Bluetooth Headset” check box,
the wired headset provides the audio.
The Bluetooth wireless technology headset can work only if it is within
range of the phone; as the wireless headset approaches the edge of its
radio range, the audio quality degrades and radio interference noise
increases. When the wireless headset is in connecting range, the
Headset key controls the wireless headset, even if a wired headset is
attached. If a wireless headset moves out of connecting range, a special
beep sounds in the headset indicating the connection was lost.
When you do not want to use your Bluetooth technology headset
If a Bluetooth wireless technology headset is connected, and you want to
use the wired headset, you can switch between the two. It is not
necessary to unpair or disable the wireless headset.
You can switch between a wired and wireless headset and back again
either when the phone is idle or during an active call.
To switch between a wired headset and a wireless headset:
1. Double-press the Headset key to open
the Bluetooth Setup dialog.
2. Press the Left/Right navigation key to
select the “Use BT Headset” item.
(Headset)