Filter
Top Products
i2021 ISDN Teleset
14
The Auto-Install programming choices are:
n Adjust Contrast – Select Yes or No.
n SPID – If the switch supports Auto-SPID you will be prompted to
choose a SPID. If your switch does not support Auto-SPID, press
the “Change” softkey and enter the SPID. After entering the SPID
press “Save”.
n The Teleset will attempt to initialize. If there is a problem the
Teleset will prompt you to correct the SPID and/or switch type.
n The Teleset will download its configuration from the switch. If
Parameter Downloading is not available, you will be prompted to
program the Teleset manually.
n Backlight – Select On, Off, or Dynamic.
n Enter the Date and Time.
n Adjust the Ring Pattern – Select Yes or No.
n Set the 2
nd
ring Option – Select Continuous, Partial, or No Ring.
n Set Primary Call Appearances.
n Set Priority Call Appearances.
n Set Terminate Only Call Appearance.
n Set an Intercom Key.
n Set Speed Dial Keys.
n Set the Alarm Clock.
n Set a Password.
AUTO-SWITCH
With Auto-Switch detection, the i2021 determines the type of switch to
which you are connected. Should you decide to manually program the
switch type, Auto-Switch detect will tell you if a different type of switch is
found. You will then be given the opportunity to correct the switch type.
NOTE: Auto-Install will only run when the i2021 is in the default
mode.
NOTE: You can abort the T-Wait countdown timer at any time by
pressing the Speaker key or any touchtone keypad digit.
NOTE: To default the i2021 press MENU and enter 91 from the
dial keypad. Press the “YES” softkey to complete the
default.
WARNING: DEFAULTING THE i2021 WILL ERASE ALL OF
THE MEMORY.