Filter
Top Products
i2021 ISDN Teleset
13
Choosing Search returns the next screen, assuming the Directory is
empty.
Connecting THE i2021- AUTO-INSTALL
1. Assemble the i2021
2. Verify the PS1/PS2 switch located on the bottom of the Teleset is
set correctly. See page 6 for further information on setting the
PS1/PS2 switch.
3. Verify the Terminating Resistor (TR) switch is set correctly. See
page 6 for further information on setting the TR switch.
4. Connect one end of the eight-pin mounting cord to the ISDN Line-
In jack on the bottom of the Teleset. Connect the other end of the
cord to the S/T jack on your NT1 or ISDN telephone wall jack.
5. Remove the protective film on the display.
6. Label and install the designation card
AUTO-INSTALL
The i2021 is equipped with an Auto-Install feature. The purpose of Auto-
INSTALL is to ensure a complete and painless installation. In this mode,
the i2021 will first detect the type of switch the i2021 is connected to, and
then will attempt to Auto-SPID. The switch will automatically download the
features. The i2021 will then step through each of its programming
choices and give you the opportunity to make a selection. After you have
made the selection press the “MORE” key to continue.
NOTE: Make sure the logo plate is installed
NOTE: You may abort the Auto-Install by pressing the Menu
key at any time