Filter
Top Products
SX-200 General Information Guide
166 Revision A 50003510
Six softkeys gives access to other modes of operation:
•Audits
• Guest Search
•Quit
• Refresh (used to recalculate totals)
• Room Search
• Room Update.
Hotel/Motel - Internal Number Block
Provides room number confidentiality in Hotels. The hotel operator has the choice of displaying
the room number on the telephone display for Guest to Guest calls. See Internal Number Block,
page 172.
Hotel/Motel - Maid in Room Status Display - SUPERSET Display Telephones
This feature allows an authorized SUPERSET display telephone to determine which guest
rooms have maids in them.
Hotel/Motel - Message Lamp Test
The Message Waiting Lamp on a guest room telephone is tested automatically whenever the
room status changes from occupied to vacant and there is no message waiting. It runs whether
the change was made from a Front Desk Terminal of from an Attendants Console. However
there is no indication at the Front Desk Terminal that it has run. If there is a failure, notification
is through the alarm icon at the Console. The test verifies lamp operation and confirms that the
telephone is still connected in the room. The test does not verify bell operation.
Hotel/Motel - Message Register
The Message Register tracks the number of completed external calls or call units for each
extension. There are two modes of operation. The first counts the number of external calls
made by each room. The second keeps track of meter pulses being sent from the far end to
the associated trunk circuit. These pulses can be used to determine the amount charged against
the guestroom making the call.
The Attendant Console displays the current value of the message register for a room each time
a room number is entered. The message register can be cleared by the Attendant from the
Console or automatically upon requesting an audit. Clearing the message register can be
recorded on a system printout. Meter pulses are recorded in SMDR. See Station Message
Detail Recording (SMDR).
Hotel/Motel - Multi-user
Four front desk terminals can run the Hotel/Motel application at the same time. However, two
terminals cannot edit information for the same room at the same time. The Front Desk Terminal
also checks that the room is not being accessed by an Attendant Console. If it is, the message