Filter
Top Products
Menu System - Super User Operation
The first menu item is Support and it is used for enabling
or disabling the Call Waiting Notification service. A third
option “Dial Spec.“ makes it possible to control the
Support setting using the AT shell command
1
. Choose the
settings by pressing
and press leave the menu.
The second menu item is Limit Calls. The user may not
want all calls to interrupt the MPDS sessions. It is possible
to enter up to five phone numbers that are allowed to
interrupt the MPDS sessions while all others will be
rejected. If Limit Calls is set to “Enabled” only the five
phone numbers are allowed to interrupt. If Limit Calls is
set to “Disabled” all calls are allowed to interrupt. The
third option “Dial Spec.“ makes it possible to control the
Limit Calls setting using the AT command
2
. Please note
that the Limit Calls service is not supported by the LES at
present time. However, it will most likely be available in
near future. Choose the settings by pressing
and press
leave the menu.
The third menu item is Handset and it contains two sub
items: Notification and Ring Tone. Notification can be
either Yes or No and it controls whether or not the 4-Wire
Handset should be used for Call Waiting Notification. Ring
Tone can be used for choosing among the 8 Ring Tones.
4
1
If “Dial Spec.“ is chosen, support of Call Waiting Notification can
be controlled using the AT shell command “+WCWNS=<value>”
during the MPDS call setup. Possible values for the AT shell
command are: 0 =
DISABLED, 1 = ENABLED, 2 = AUTOMATIC.
2
If “Dial Spec.“ is chosen the Limit Calls setting can be
controlled using the AT command
2
“+WCWNR=<value> during the
MPDS call setup. Possible values are: 0 =
DISABLED, 1 =
ENABLED.
May 2005 65