Filter
Top Products
Introduction Hardware Interfaces
2
The transceiver has one 4-wire handset port with RS-485
data control. The Handset can be used to set-up the
terminal and it can be used to make or receive phone calls.
Ethernet interface:
The Ethernet interface is a RJ45 connector. It can be used
for the following service types:
• MPDS service
• Connection of an IP Router
RS-232 interface:
The RS-232 interface is a standard 9-pin serial port, with a
maximum port speed of 115.2 kbps. It can be used for the
following service types:
• MPDS service
• 9.6 kbps data
• Configuration of the terminal via FleetCP software
• Connection of a IP Router
When using the FleetCP program, the PC must be
connected to the RS-232 interface (see section 5.1).
10 May 2005