Filter
Top Products
TK-8180
7
2. Radio Interface Cable (KCT-40 : Option)
The KCT-40 connection cable kit is used to connect the
TK-8180 transceiver to the KDS-100 (Mobile data terminal),
KGP-2A (Modem GPS receiver), KGP-2B (Modem GPS con-
troller) or through the KCT-36 extension cable.
2-1. Connecting the KCT-40 cable to the transceiver
1. Remove the D-sub cap on the rear of the transceiver. ( q )
2. Connect the D-sub connector of the KCT-40 to the D-sub
25-pin terminal of the transceiver. ( w )
3. Connect the 15-pin connector of the KCT-40 to a KDS-100,
KGP-2A, KGP-2B or through a KCT-36 extension cable.
( e )
Note : You must setup using the KPG-89D.
KDS-100, KGP-2A,
KGP-2B or through
KCT-36 extension cable
q
e
w
2-2. Terminal function
D-sub 25-pin
TK-7180
Molex 15-pin
KDS-100 KGP-2A/2B
Pin No. Function Pin No. Function Function
1----
2----
3----
4----
5DI5DO DO
6----
7 GND 3 GND GND
8 AIO8 9 TXS/LOK TXS/LOK
9 TXD2 15 RXD RXD
10 RXD2 14 TXD TXD
11 - ---
12 AIO7 11 MM MM
13 AIO6 6 PTT PTT
14 SB 1 SB SB
15 - ---
16 - ---
17 - ---
18 - ---
19 DEO 4 DI DI
20 AIO5 8 SQ SQ
21 AIO4 10 AM AM
22 AIO3 13 - DISP OFF
23 AIO2 12 - -
24 AIO1 7 DTC DTC
25 - ---
1. Ignition Sense Cable (KCT-46 : Option)
The KCT-46 is an optional cable for enabling the ignition
function. The ignition function lets you turn the power to the
transceiver on and off with the car ignition key.
1-1. Connecting the KCT-46 cable to the transceiver
1. Open the KCT-46 fuse holder and insert a mini blade fuse
(3A). ( q )
2. While holding a clear protective cover, remove the black
cap at the end of the yellow cable (ignition sense cable) of
the transceiver. ( w )
3. Connect the plug of the KCT-46 to the yellow cable termi-
nal of the transceiver. ( e )
4. Connect the other end of the KCT-46 to the ignition line of
the car. ( r )
Note : You must setup using the KPG-89D.
q
w
e
r
Iginition line
of the car
F52-0019-05
Fig. 1
Fig. 2
INSTALLATION