Filter
Top Products
TK-8180
3
SERVICE
This radio is designed for easy servicing. Refer to the
schematic diagrams, printed circuit board views, and align-
ment procedures contained in this manual.
NOTE
• If you do not intend to use the speaker 3.5-mm jack and
the D-sub 25-pin connector, fit the supplied speaker-jack
cap and D-sub cap to stop dust and sand from getting in.
• If the transceiver is turned ON or OFF when the power-on/
off status message is enabled, the transceiver sends the
status.
GENERAL / SYSTEM SET-UP
Speaker
jack cap
D-sub
cap
Power input
connector
Ignition
sense cable
Antenna
connector
Merchandise received
License and frequency allocated by FCC
Choose the type of transceiver
Transceiver programming
See page 4.
A personal computer (IBM PC or compatible), programming
interface (KPG-46), and programming software (KPG-89D)
are required for programming.
Are you using
the remote kit?
Are you using
the ignition sense cable?
Are you using
the radio interface cable?
Are you using
the public address?
Are you using
the voice guide & storage
unit?
KRK-10
KCT-46
KCT-40
KCT-36 Extension cable
KGP-2A
Modem GPS receiver
or
KGP-2B
Modem GPS controller
or
KDS-100
Mobile data terminal
KAP-2
VGS-1
YES
NO
YES
NO
YES
NO
YES
NO
YES
NO
Supplied microphone
Delivery
Are you using
the external speaker?
Are you using
the keypad microphone?
KES-3 or KES-5 External speaker
KMC-32 or KMC-36
YES
NO
YES
NO
Desk top microphone KMC-9C
See page 9.
See page 7.
See page 7.
See page 8.
See page 10.
(Option)
(Option)
(Option)
(Option)
(Option)
(Option)
(Option)
(Option)
(Option)
(Option)
Frequency range RF power Type
450~520MHz
30W
(490~520MHz : 25W)
K
SYSTEM SET-UP