Filter
Top Products
6
english
JABRA SP200
PAIRING YOUR JABRA SP200 WITH
YOUR MOBILE PHONE
The Speakerphone can be connected to a mobile phone using a
procedure called ‘pairing’. By following a few simple steps, a phone
can be paired with the speakerphone in a matter of minutes.
1 Put the speakerphone in pairing mode
- When you turn on your Jabra SP200 for the rst time, the
speakerphone will automatically start up in pairing mode – i.e.
it can be detected by your phone. When the speakerphone is in
pairing mode the blue LED will ash rapidly.
2 Set your Bluetooth phone to ‘search’ for the Jabra SP200
- Follow your phone’s instruction guide. First make sure that
Bluetooth is activated on your mobile phone. Then set your
phone to search for devices. This usually involves going to a
‘setup,’ ‘connect’ or ‘Bluetooth’ menu on your phone and select-
ing the option to ‘search’ or ‘add’ a Bluetooth device.*
3 Your phone will nd the Jabra SP200
- Your phone will nd the speakerphone under the name “Jabra
SP200”. Your phone then asks if you want to pair with the
Jabra SP200. Accept by pressing ‘Yes’ or ‘OK’ on the phone and
conrm with the passkey or PIN = 0000 (4 zeros). Your phone
will conrm when pairing is complete.
CONNECTIVITY
SELECT
MobilSurf
BLUET O O TH
Infrared port
Wap options
Synchronization
Networks
DEVICES FOUND
Jabra SP200
Jabra SP200
OK
Passkey:
****
HANDSFREE
SELECT
Jabra SP200
added.
The handsfree is
now ready for use
SELECT
Manual pairing mode
If you wish to use the speakerphone with a dierent phone, or
if the pairing process was interrupted, you can manually set the
speakerphone to pairing mode.
Turn the speakerphone on. Press and hold the answer/end button
for approximately 5 seconds until the blue LED light stars blinking
rapidly. Then repeat steps 2. and 3. in the above pairing guide.
* Phone dependent