Filter
Top Products
17
english
JABRA SP200
CERTIFICATION AND SAFETY APPROVALS
FCC:
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation. Users are not permitted to make changes
or modify the device in any way. Changes or modications not
expressly approved by Jabra (GN Netcom, Inc.) will void the user’s
authority to operate the equipment. See 47 CFR Sec. 15.21. This
equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning
the equipment of and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit dierent
from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for
help.
The device and its antenna must not be co-loaded or operating in
conjunction with any other antenna or transmitter.
Industry Canada Operation is subject to the following two
conditions: (1) This device may not cause interference and (2) This
device must accept any interference, including interference that
may cause undesired operation of the device. See RSS-GEN 7.1.5.
The term “IC:” before the certication/registration number only
signies that registration was performed based on a Declaration
of Conformity indicating that Industry Canada technical
specications were met. It does not imply that Industry Canada
approved the equipment.