Filter
Top Products
42
Inter-Tel
®
Model 8524/8525/8526 User Guide
GETTING STARTED
To enable DND:
1. Press , , and dial .
2. Dial the desired two-digit number for the message you wish to use.
3. If desired, customize the second display line by entering the desired numbers or
letters as described below:
• Remain in numeric mode: Press the dialpad buttons to dial the desired num-
bers. If you make a mistake, you must press
and start over.
• Change to alphanumeric mode: Press and then press the dialpad
buttons to enter the desired characters. (See the table below.) The number of
times a button is pressed determines which character is entered. For example,
33377744432999 would enter “FRIDAY.” When adjoining characters are
located under the same button, press once to advance to the next
character. For example, 6 666 6632999 would enter
“MONDAY.” (Note that letters correspond to the letters printed on dialpad
buttons 1-9.) Press twice to leave a space, or press Backspace but-
ton (e.g., ) to back space.
NOTE: To use the Backspace button, you must pre-program one of the fea-
ture buttons on your endpoint to use the Backspace button (feature code 314).
Refer to page 59, Programming You Feature Buttons section for details on
how to program the backspace button.
4.
Press to hang up.
*The character available depends on the software version.
5. To cancel Do-Not-Disturb:
Press , , and dial .
NUMBER OF TIMES BUTTON IS PRESSED
BUTTON 1 2 3 4 5
1
-&()1
2
ABC' 2
3
DEF ! 3
4
GH I * 4
5
JKL# or /
*
5
6
M N O N or #
*
6
7
PQRS7
8
TUV?8
9
WXYZ9
0
@:.,0
START LINE 6
END
FNC 6
FNC 2
FNC 2 FNC 2
FNC 2
FNC 2
END
START LINE 6