Icom IC-208H Two-Way Radio User Manual


 
44
7
SCAN OPERATION
7
Skip channel setting
[
The memory skip function speeds up scanning by checking
only those memory channels not set as skip channels. Set
skip channels as follows.
q Select a memory channel:
Push [M/CALL•PRIO] to select memory mode.
Rotate [DIAL] to select the desired channel to be a skip
channel.
w Push
[SET•LOCK]
to enter set mode.
e Push
[SET•LOCK]
or [S.MW•MW] several times until
“CHS” appears as shown above.
r Rotate [DIAL] to turn the skip function ON or OFF for the
selected channel.
•“~” appears : The channel is skipped during scan.
(CHS-ON)
•“P~” appears : The channel is skipped during scan and the
programmed frequency is skipped during VFO scan, such as
programmed scan.
(CHS-ON)
•“~” disappears : The channel is scanned during scan.
(CHS-OF)
t Push [MONI•DTMF] to exit set mode.
z Select a memory channel.
Select memory mode by pushing [MR/CALL].
Push [Y] or [Z] to select the desired channel
to be a skip channel.
• Direct memory channel selection is also available.
x Push [
SET
B(D-OFF)] to enter set mode.
c Push [
SET
B(D-OFF)] or [
ENT
C(T-OFF)] several
times until “CHS” appears as shown at left.
v Push [Y] or [Z] to set or cancel the skip setting.
• See item r at left for skip indicator details.
b Push [
CLR
A(MW)] to exit set mode.
SET
B
The display shows that mem-
ory channel 1 is set as a skip
channel.