Filter
Top Products
26
5
MEMORY OPERATION
4
5
■ General description
The transceiver has 512 memory channels including 10 scan
edge memory channels (5 pairs), and 2 call channels. Each of
these channels can be individually programmed with operat-
ing frequency (pgs. 11, 12), duplex direction (p. 21) and off-
set (p. 24), subaudible tone encoder or tone squelch and its
tone frequency (pgs. 20, 22, 52, 53) and skip information*
(p. 44).
In addition, a total of 10 memory banks, A to J, are available
for usage by group, etc.
*except for scan edge memory channels.
■ Memory channel selection
D Using the tuning dial
q Push [M/CALL•PRIO] several times to select memory
mode.
•“!” indicator appears
w Rotate [DIAL] to select the desired memory channel.
• Programmed memory channels only can be selected.
D Using the [Y]/[Z] keys
z Push [MR/CALL] to select memory mode.
x Push [Y] or [Z] to select and set the desired
memory channel.
• Pushing [Y]/[Z] for 1 sec. activates a scan.
• If scan is activated, push [Y]/[Z] again or push
[
CLR
A(MW)] to stop it.
D Using the keypad
z Push [MR/CALL] to select memory mode.
x Push [
ENT
C(T-OFF)] to activate the keypad
for numeral input.
c Push 3 appropriate digit keys to input a chan-
nel number.
• Blank channel can be selected.
• Push only 1 appropriate digit key, [
MONI
1(BANK)],
[
SCAN
2(T-SCAN)], [
PRIO
3(PTT-M)],
[
HIGH
4(DTCS)] or [
MID
5(DTCSS)] then push
[
MM
(TONE-1)] or [
SQL
Z #(16KEY-L)] to select scan
edge channels. “
MM
” and “#” can be used for “A”
and “b” respectively.
MR/CALL
MR/CALL
Y/Z
[M/CALL•PRIO] “!” appears