Grandstream Networks GXP11O5 IP Phone User Manual


 
Grandstream Networks, Inc. GXP1100/1105 User Manual Page 23 of 34
Firmware version: 1.0.1.110 Last Updated: 01/2012
Call Progress Tones
Using these settings, users can configure ring or tone frequencies based on
parameters from local telecom. By default, they are set to North American standard.
Frequencies should be configured with known values to avoid uncomfortable high
pitch sounds.
Syntax: f1=val,f2=val[,c=on1/off1[-on2/off2[-on3/off3]]];
(Frequencies are in Hz and cadence on and off are in 10ms)
ON is the period of ringing (“On time” in ‘ms’) while OFF is the period of silence. In
order to set a continuous ring, OFF should be zero. Otherwise it will ring ON ms and a
pause of OFF ms and then repeat the pattern. Up to three cadences are supported.
Disable Call Waiting
Default is “No”. If set to “Yes”, the call waiting feature will be disabled.
Disable Call
Waiting Tone
Default is “No”. If set to “Yes”, the call waiting tone will be disabled.
Disable Direct IP Calls
Default is “No”. If set to “Yes”, direct IP calls will be disabled.
Use Quick IP Call
Mode
Dial an IP address under the same LAN/VPN segment by entering the last octet in the
IP address.
In the Advanced Settings page there is an option “Use Quick IP-call mode”. Default
setting is “No”. When set to “Yes”, and #XXX is dialed, where X is 0-9 and XXX
<=255, phone will make direct IP call to aaa.bbb.ccc.XXX where aaa.bbb.ccc comes
from the local IP address REGARDLESS of subnet mask.
#XX or #X are also valid so leading 0 is not required (but OK). See Quick IP Call
Mode for details.
Disable Conference
Default is “No”. If set to “Yes”, 3-way conference will be disabled
Enable MPK sending
DTMF
Default is No. If set to “Yes”, Multi Purpose keys can be sent as DTMF during the call.
Enable FLASH key as
CONF
Default is No. If set to “Yes”, FLASH key can be used to establish 3-way conference.
Disable Transfer
Default is “No”. If set to “Yes”, transfer will be disabled.
Auto-Attended
Transfer
Default is “No”. If set to “Yes”, the phone will use attended transfer by default.