Filter
Top Products
Grandstream Networks, Inc. GXP1100/1105 User Manual Page 15 of 34
Firmware version: 1.0.1.110 Last Updated: 01/2012
Configuration Guide
The GXP1100/1105 can be configured in two ways:
- IVR MENU from the keypad
- Web GUI embedded on the phone
CONFIGURATION VIA IVR MENU
GXP1100/1105 has a built-in voice prompt menu for simple device configuration. Pick up the handset and dial
“***” to use the IVR menu.
Table 9: GXP1100/1105 IVR Menu Definitions
Menu Voice Prompt Options
Main Menu
“Enter a Menu Option”
Press “*” for the next menu option.
Press “#” to return to the main menu.
Enter 01 – 05, 07, 10 - 17, 47, 86 or 99 Menu option.
01
“DHCP Mode”
“PPPoE Mode ”
“Static IP Mode”
Enter “9” to toggle the selection.
If users select “Static IP Mode”, users need configure all the
IP address information through menu 02 to 05 as below.
If users select “Dynamic IP Mode”, the device will retrieve all
IP address information from DHCP server automatically after
user reboots the device.
02
“IP Address “ + IP address The current WAN IP address is announced.
Enter 12-digit new IP address if in Static IP Mode.
03
“Subnet “ + IP address Same as Menu option 02.
04
“Gateway “ + IP address Same as Menu option 02.
05
“DNS Server “ + IP address Same as Menu option 02.
07
“Preferred Vocoder” Enter “9” to go to the next selection in the list:
1. PCMU
2. PCMA
3. iLBC
4. G-726
5. G-723
6. G-729
10
“MAC Address” Announces the MAC address of the unit.
13
“Firmware Server IP Address” Announces current Firmware Server IP address. Enter 12 digit
new IP address.
14
“Configuration Server IP Address” Announces current Config Server Path IP address. Enter 12
digit new IP address.
15
“Upgrade Protocol” Upgrade Protocol for firmware and configuration update. Enter
“9” to toggle between HTTP, TFTP and HTTPS.
16
“Firmware Version” Firmware version information.
17
“Firmware Upgrade” Firmware upgrade mode. Enter “9” to toggle among the
following three options:
1. always check
2. check when pre/suffix changes
3. never upgrade
47
“Direct IP Calling” Enter the target IP address to make a direct IP call, after dial
tone. (See Make a Direct IP Call section.)