Filter
Top Products
25BusinessPhone – Dialog 4222 Office / Dialog 3211 & 3212
Outgoing Calls
u Lift the handset when you are called back.
(You can also press the Line or Loudspeaker key to answer in
handsfree mode.)
Notes: It is not possible to do a new request on a key
holding an already activated request until the existing one is
cancelled.
When the Automatic Redial lamp is rapidly flashing, your
telephone is busy and you cannot receive or make new
calls.
The number of redial attempts and how long the function is
active is programmed by your system administrator.
If you have activated a diversion on your telephone, this
function is not available.
If Tandem configuration is activated, the secondary
telephone cannot use this function. See section “Tandem
configuration” on page 78.
Cancel
ÕÔ Press the relevant programmable key to cancel the
Automatic Redial request (pre-programmed).
Note: Depending on system programming, the Automatic
Redial request could be cancelled automatically.
Pause
It is possible to pause all of your successfully activated requests by
programming a separate pause key, see section “Program a
function” on page 88.
Ô Press to pause (pre-programmed).
The requests are paused and the key lamps of the Automatic
Redial keys are flashing slowly.
ÕÔ Press to resume Automatic Redial (pre-programmed).
AUTO REDIAL CALL
ANDERSEN A 200
Automatic
Redial1
Pause auto
redial
Pause auto
redial
Dialog4222En.book Page 25 Tuesday, August 24, 2004 5:31 PM