Filter
Top Products
49
Nothing Comes Close to a Cobra
®
Advanced Operation
Operating Your Radio
Channel Scan Mode
During Channel Scan mode, the radio will rapidly switch
from channel to channel through all the channels. Whenever
any activity is detected, the radio will stop the scan for 10
seconds to allow you to listen briefly on that channel. The
radio will then continue to scan unless you switch out of the
Channel Scan mode.
NOTE
The radio must be squelched for Channel Scan mode
to function. See page 31 for Squelch procedure.
To Enter Channel Scan:
1. From Marine Standby mode, press the SCAN
button. The radio will immediately begin to scan the
entire channel map selected in the active channel
map. The SCAN icon will show on the LCD.
2. A signal on any channel will stop the scan for 10
seconds to allow you to listen to the traffic on that
location.
3. Press the Channel Up/Down button to resume
scanning the Channel Scan channels or to change
the scan direction.
4. To EXIT Channel Scan mode, press the SCAN
button again. The SCAN icon will disappear from the
LCD and the radio will return to Marine Standby
mode.
SCAN Button
SCAN Icon
Scanning
Channel Up/Down Button
MRHH415EU-Body.qxp:400_Body 12/15/06 10:01 AM Page 49