Filter
Top Products
52 53
I cannot dial out
• First try all the suggestions in the item I cannot get a dial tone.
• Make sure you have a dial tone before dialing. The cordless handset may
take a second or two to nd the telephone base and produce a dial tone.
This is normal. Wait an extra second before dialing.
• Check that all the telephones connected to the same telephone line are
hung up.
• Make sure to set the dial mode to the correct setting (pulse dialing or
tone dialing) for the service in your area.
• Eliminate any background noise. Noise from a television, radio or other
appliances may cause the telephone to not dial out properly. If you cannot
eliminate the background noise, rst try muting the cordless handset
before dialing, or dialing from another room in your home with less
background noise.
• If the other telephones in your home are having the same problem, the
problem is in your wiring or telephone service. Contact your telephone
service provider (charges may apply).
My cordless handset isn’t performing normally
• Make sure the power cord is securely plugged into the telephone base.
• Plug the power adapter into a different, working electrical outlet not
controlled by a wall switch.
• Move the cordless handset closer to the telephone base. You might have
moved out of range.
• Reset the telephone base. Unplug the electrical power. Wait for 15
seconds then plug it back in. Allow up to one minute for the cordless
handset and telephone base to reset.
• Other electronic products such as HAM radios and other DECT phones
can cause interference with your cordless telephone. Try installing your
telephone as far away as possible from these types of electronic devices.
"Out of range or no pwr at base" appears on my cordless
handset
• Ensure that the telephone base is powered up.
• Place the cordless handset in the telephone base for one minute to allow
the cordless handset and base to synchronize.
• Move the cordless handset closer to the telephone base. You might have
moved out of range.
• Reset the telephone base. Unplug the electrical power. Wait for 15
seconds then plug it back in. Allow up to one minute for the cordless
handset and telephone base to reset.
• Other electronic products such as HAM radios and other DECT phones
can cause interference with your cordless telephone. Try installing your
telephone as far away as possible from these types of electronic devices.
I experience poor sound quality when using the speakerphone
• For increased sound quality while using the speakerphone, place the
handset on a at surface with the dial pad facing up.
• When using a speakerphone, controlling background noise in your
environment is essential. While you are listening to your party, press
MUTE/X to temporarily turn your microphone off. When it is
your turn to speak, remember to press MUTE/X again to turn the
microphone on.
• Excessive background noise will cause a speakerphone to fade in and out.
Try controlling the background noise by turning off any audio devices near
the speakerphone. Also, try to avoid interrupting the person at the other
end of the conversation while they are speaking. If background noise
cannot be controlled, you should terminate speakerphone operation and
return to normal handset mode.
I hear other calls while using my telephone
• Disconnect the telephone base from the telephone wall jack, and plug in
a different telephone. If you still hear other calls, the problem is probably
in your wiring or telephone service. Call your telephone service provider
(charges may apply).
TROUBLESHOOTING
TROUBLESHOOTING