Filter
Top Products
48 49
Remote Access Code
To access your answering system remotely from any touch-tone telephone,
you need to enter a two-digit number (00-99). Unless you change it, the
remote access code is 19.
To change the remote access code:
1. In idle mode, press <MENU/SELECT>, then <UP/DOWN> to select
Answering sys.
2. Press <MENU/SELECT>, then <UP/DOWN> to select Ans sys
setup.
3. Press <MENU/SELECT>, then <UP/DOWN> to select Remote
Code.
4. Press <MENU/SELECT>, then use the keypad to enter a two-digit
remote code.
5. Press <MENU/SELECT> to conrm.
Remote Access
You can access the answering system remotely by dialing your home telephone
number from any touch-tone telephone.
To remotely access the answering system:
1. Dial your telephone number from any touch-tone telephone.
2. When the answering system answers, enter the two-digit remote
access code (19, unless you have changed it; refer to Remote access
code). The answering system automatically announces the number of
messages (new or old) if there are any.
3. If there are new messages, the answering system automatically begins
to play new messages only.
-OR-
If there are no new messages, the answering system automatically
begins to play all old messages.
4. You can also enter the remote commands - see table.
5. Hang up to end the call and save all messages.
Play all messages
1
Press to listen to all messages. If there are new messages,
the system plays back only the new messages (oldest rst).
If there are no new messages, the system plays back all old
messages (oldest rst).
Play new messages
2
Press to listen to new messages only.
Delete a message
3
Press during a message playback to delete the current
message.
Delete all old
messages
33
Press to delete all old messages.
Replay current or
previous
message
4
To repeat the message currently playing, press 4 after
the answering system plays the day and time the current
message was received.
To listen to the previous message, press 4 while the
answering system is playing the day and time the current
message was received.
Stop
5
Press to stop playback and recording.
Play help menu
* 5
Press to listen to a list of remote commands.
Skip to next
message
6
Press during playback to skip the current message and
advance to the next message.
Record an
announcement
* 7
Press to record a new announcement. Begin speaking after
the long beep.
Exit or hang up
8
Press to end remote access (the call is terminated).
Turn system on
or off
0
Press to turn the answering system on or off.
ANSWERING SYSTEM SETTINGS
ANSWERING SYSTEM SETTINGS