Filter
Top Products
50 51
Note:
• If you do not enter a valid remote access code, the system answers the
call automatically.
• If the date and time are not set when a message is recorded, the system
announces, “Time and date not set.”
• If there are no messages in the answering system, the system announces,
“You have no message.”
• At the beginning of new message playback, if the answering system has
less than three minutes of recording time left, the answering system
announces, “Less than three minutes to record.” If the memory is full, the
answering system announces, “Memory is full.”
• If you pause for more than four seconds during remote access, you hear
a help menu listing all features and commands. If there is no command for
another 20 seconds, the call ends automatically.
• If the memory is full, the answering system answers after 10 rings and
announces, “Memory is full. Enter the remote access code.” Enter your
remote access code to access the messages.
• When the answering system is turned off, the telephone answers after 10
rings, and announces, “Please enter your remote access code.”
If you have difculty with your telephone, please try the suggestions below.
My telephone doesn’t work at all
• Make sure the power cord is securely plugged in.
• Make sure that the battery connector is securely plugged into the
cordless handset.
• Make sure the telephone line cord is securely and rmly plugged into the
telephone base and the telephone wall jack.
• Charge the battery in the cordless handset for at least 16 hours. For
optimum daily performance, return the cordless handset to the telephone
base or charger when not in use.
• If the battery is depleted, it may take approximately 30 minutes to charge
the handset before it shows Low battery.
• Reset the telephone base. Unplug the electrical power. Wait for
approximately 15 seconds, then plug it back in. Allow up to one minute
for the cordless handset and telephone base to reset.
• You may need to purchase a new battery. Use only the supplied
rechargeable battery or contact the customer service helpline found in
this User Guide to purchase the correct replacement batteries.
I cannot get a dial tone
• First try all the suggestions above.
• Move the cordless handset closer to the telephone base. You might have
moved out of range.
• If the previous suggestions don’t work, disconnect the telephone base
from the telephone wall jack and connect to a different telephone. If there
is no dial tone on that telephone either, the problem is in your wiring or
telephone service. Contact your telephone service provider (charges may
apply).
• Your telephone line cord might be malfunctioning. Try installing a new
telephone line cord.
TROUBLESHOOTING
ANSWERING SYSTEM