Filter
Top Products
CHAPTER
5-1
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator’s Guide (SIP)
OL-3410-01
5
Parameters and Defaults
This section provides information on the parameters and defaults that you can use to create your own
Cisco ATA configuration file. This section also includes the voice configuration menu code for each
parameter that has such a code, and each category of parameter type lists the color portion of the web
configuration screen where the parameter is located. Types of parameters include:
• User Interface (UI) Parameter, page 5-3
• Configuration Parameter, page 5-4
• Parameters for Configuration Method, page 5-4
• Network Parameters, page 5-6
• Account Information Parameters, page 5-8
• Backup Server Parameters, page 5-13
• SIP Parameters, page 5-14
• Operating Parameters, page 5-19
• Optional Feature Parameters, page 5-35
The following list contains general configuration information:
• Your configuration file must begin with #txt.
• The Cisco ATA uses the following parameter types:
–
Alphanumeric string
–
Array of short integers
–
Boolean (1 or 0)
–
Bitmap value—unsigned hexadecimal integer (for specifying bits in a 32-bit integer)
–
Extended IP address—IP address followed by port number (for example, 192.168.2.170.9001)
–
IP address (e.g. 192.168.2.170)
–
Integer (32-bit integer)
–
Numeric digit string
Note The term Cisco ATA is used throughout this manual to refer to both the Cisco ATA 186 and the
Cisco ATA 188, unless differences between the Cisco ATA 186 and Cisco ATA 188 are explicitly stated.